Pe Extrustion Blow Molding Machine

Precautions for production and operation of extrustion  blow molding machine

If the new pe extrusion blow molding hollow molding unit is purchased, the machine assembly shall be checked. After the equipment is installed according to the requirements of the manual, the whole unit shall be calibrated;Pet Stretch Blow Moulding Machine manufacturers and suppliers in china.

Install the mold water cooling pipe and check whether the direction is correct;

Whether the operators and control devices are convenient in operation;Pe Extrustion Blow Molding Machine

Feeding and placement of finished products;Extrustion Blow Molding Machine

Whether the recycling process of waste products is smooth without affecting normal operation

Whether the position of relevant Auxiliary Equipment is appropriate.pet stretch blow moulding machine

Only after the inspection results of equipment assembly meet the production and standard requirements, can the equipment be in good assembly condition.

The system pressure of the extrustion blow molding  machine has been set before leaving the factory. It can not be adjusted without special circumstances to avoid damage to the hydraulic system caused by high or low pressure or affecting the normal operation of the machine.

It is strictly forbidden for workers to go to the machine platform for feeding to avoid electric shock, scalding and falling from height. (The machine shall be equipped with automatic feeding device).

Before the operation of the full-Automatic Blow Molding Machine, raise the machine table to a proper position to ensure that the machine head and the template do not collide and avoid damage to the equipment.

When adjusting the photoelectric switch for mold shifting and mold closing, the main oil pump should be turned off to avoid accidents.